Now it's time to turn your attention to a more exciting structure: the cascade design itself. With the pond complete, that means one of your two structures is out of the way. Since this water feature is intended only for decoration and for relaxation (it's not a fish pool or koi pond), there's no reason to keep it running if you're not there to enjoy it. Of course, if you're frugal, you'll unplug the pump when you're not around anyhow, to save money on electricity. Should the pond go dry due to water loss, you'll burn out the pump.Ĭonsequently, you must turn off the pump overnight or when leaving your property.
But regardless of how well you do at minimizing water loss, it is prudent to check the level of your waterfall pond water periodically. Not even enough to suit you? Then extract the liner and scrape the sand at the bottom this way and that to even the liner until you're satisfied it is level.īefore moving on to the waterfall structure itself, a word of caution: Be sure to consider strategies for minimizing water loss from the start. Determine whether it's even by placing a carpenter's level on top of it (front to back, as well as left to right). Put the preformed liner into the hole for the waterfall pond. This slight elevation will minimize the problem of soil spilling into the waterfall pond. Apply approximately one inch of sand at the bottom, so that the rim of the liner stands an inch or so above the ground. Indeed, plan on shoveling sand into the bottom of the hole, as sand gives you a base that is malleable (allowing you to play with the height of the preformed liner). But if the hole ends up being too big, you can correct your mistake afterward by applying sand. The depth and diameter of your waterfall pond's hole should roughly match the corresponding dimensions for your preformed liner. Besides, the overhang of the waterfall structure will just be in your way while digging.
If you were to build the cascading waterfall structure first and then dig the waterfall pond, you might undermine those rocks. This entails placing some of the bottom rocks very close to the waterfall pond. Take care of the waterfall pond structure first, simply because you'll be laying your rocks for the cascading waterfall structure in such a way that the front of it overhangs the waterfall pond. There is an easy way to guide your shovel as you dig: turn the liner over on the ground, upside-down, where you want the pond to be, and trace out your circle. The Spruce Home Improvement Review BoardĮxcavate the hole into which your liner will be inserted.
0 kommentar(er)
